SURFACE PREPARATION

ABAFLOOR PUR-20 must be applied over a suitable primer. The surface of the primer must be dry and free of any contamination. ABAFLOOR PUR-20 should be applied at intervals exceeding the specified coverage. To achieve a smooth and suitable surface, before applying ABAFLOOR PUR-20, all concrete cracks must be filled with ABADUR MP.

Concrete Surfaces: Concrete should be cured for a minimum of 28 days before coating. The moisture content of the concrete should be below 4%. All surfaces should be clean and dry.

SURFACE PREPARATION SHALL NOT TAKE PLACE IN THE FOLLOWING CONDITIONS:

• At temperatures below 15 ºC
• When the relative humidity is greater than 80%
• When the surface temperature is less than 3 ºC above the dew point

APPLICATION METHOD

The material is supplied in two containers as a unit. Always mix one whole unit in the proportion supplied. Once the unit has been mixed, it must be used within the working pot life specified.

1. Agitate Part A and B separately with a power agitator.
2. Combine all the contents of part B with part A and mix thoroughly with an electric mixer.

Mix thoroughly for at least three minutes, scraping the container bottom and side to assure complete mixing. There is no induction or waiting time required after mixing before application.

The exothermic nature of the hardening reaction may increase the temperature of the mixture in the bucket, which causes loss of efficiency. As with all high-performance coatings, this product must be applied as recommended to achieve the maximum protection for which it is formulated.

Pour ABAFLOOR PUR-20 on the ground and spread it using a flat trowel. Within 10 minutes, roll the surface with a pin roller to remove air bubbles. Applying a minimum thickness of 1-2 mm, ABAFLOOR PUR-20 typically provides a smooth surface with very good mechanical characteristics.

• In a hot climate, the temperature of the material should be 20-25 °C before mixing. Otherwise, pot life becomes very short.
• Do not think for any reason.
• Do not apply the flooring material when wind speed is in excess of 7 m/s.
• Do not apply the flooring material when the ambient temperature is below 20 ºC or more than 40 ºC.
• Do not apply the flooring material when the surface temperature is below 10 ºC.

ADVANTAGES

• High initial and final mechanical strengths
• Excellent flowability and good self-leveling properties
• Easy to apply
• Excellent adhesion to substrate
• High abrasion resistance and good flexibility
• Good chemical and mechanical resistance

APPLICATION

• Hospitals and medical centers
• Oil and petrochemical industries
• Airports
• Warehouses and storage of food products
• Production halls

PHYSICAL & CHEMICAL PROPERTIES

DRYING TIME

Note: The drying time depends on the thickness of the applied coating, and all the information in this catalog is based on the recommended dry film thickness.

POT LIFE (When the material temperature is 25 °C)

PACKAGING

20 kg Total, in 2 parts (Part A: 16 kg bucket; Part B: 4 kg bucket)

STORAGE & SHELF LIFE

Shelf life: 6 months in an unopened original package.

Storage condition: should be kept in a dry and cool environment with proper ventilation in the temperature range between +20 °C and +30 °C.

HEALTH & SAFETY

This product is Flammable. Keep away from heat and open flame. Keep the container closed. Use with adequate ventilation. Avoid prolonged and repeated contact with skin. If used in confined areas, observe the following precautions to prevent hazards of fire, explosion, or damage to health:

1-Circulate adequate fresh air continuously during application and drying.

2-Use fresh air masks and explosion-proof equipment.

3- Prohibit all flames, sparks, welding, and smoking.

MSDS is available at the ABADGARAN website.

TECHNICAL SERVICE

The ABADGARAN INTERNATIONAL GROUP Technical Department is available to assist you in the correct use of our products, and its resources are at your disposal entirely without obligation.