ELASTOPRIME

SURFACE PREPARATION

All surfaces must be thoroughly cleaned and free of all loose dirt, dust, grease, loose or flaking paint, and loose surface plaster. Efflorescence or mould on masonry or concrete surfaces must be treated. Flatten gloss surfaces by thoroughly sanding and wipe cleanwith a damp cloth, then apply ELASTOPRIME as required. APPLICATION Apply using brushes, rollers or spray equipment.

• Deeper penetration into plaster and concrete gives a better adhesion to the surface Superior alkali resistance offers the best protection against alkali attack when applied onto a fully cured new cement plastered, concrete surface.

• ELASTOPRIME is most suitable for fully cured new cement plastered walls, ceilings, concrete, gypsum board partitions, etc. It is very important to use ELASTOPRIME on all areas where better penetration and alkali resistance are a high priority.

• Appearance : Emulsion white &ndashcolorless after drying
• Density : Approx. 1.0 g/cm3
• Drying tack free : Approx. 40 minutes at 23° C
• Recoat : 2 hours
• Fully dried : 7 days
• Application temp : 10-35 ° C
• Thinner/Clean up : Water
• Theoretical spreading rate : 12 m2/l

PACKAGING
20 kg plastic pails.

STORAGE &SHELFLIFE
The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.

TECHNICAL SERVICE
The ABADGARAN INTERNATIONAL GROUP Technical Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.

• ELASTOPRIME is non-toxic but is alkaline in its nature. When applying gloves &goggles should be worn. Wash off splashes to skin with water. If in eyes wash out with plenty of clean water and seek medical attention. ELASTOPRIME is non-flammable. MSDS is available at ABADGARAN website.