ELASTOPOOL

The substrate should be clean and sound, free of dust, loose particles, grease, oil, primers from previous membrane systems or bitumen. Bitumen or primers should be removed by shot blasting or mechanical means. Spalled concrete should be repaired by cutting out to sound concrete and patching with E.M.SUPER REPAIR .Cracks, holes and honeycombs must be repaired prior to application.

• Safe to use, water based acrylic formulation.
• Easy soap &water clean-up.
• One component - readily applied direct from pail.
• Excellent resistance to UV, weathering and CO2.
• Can be applied to a wide range of substrates.
• Various colors available. Color fast.
• Highly flexible - accommodates movement and minorcracking of substrates.
• No solvents or fire hazard. No pungent smell.
• Excellent long term durability.
• Fast application.
• High resin content.
• Remains flexible through use of high grade 100%elastomer acrylic polymers.
• Excellent dirt releasing ability.

• Protects and beautifies interior and exterior surfaces onto concrete and cement plaster.
• The temperature of the substrate should be minimum 10° C and at least 3° C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate. The application could be done by means of airless spray, conventional spray, brush or roller, while using brush or roller requires laying the material onto the surface, avoiding brushing out, to achievethe required film thickness per coat. A minimum of two coats are required to achieve a total dry film thickness of approximately 350 microns.

• Appearance : Colored (Blue by default)
• Density : Approx. 1.4 g/cm3
• Drying tack free : Approx. 40 minutes at 23° C
• Recoat : 2-4 hours
• Fully dried : 7 days
• Application temp : 10-35 ° C
• Adhesion to Concrete : >2 MPa (Concrete failure) According to ASTM D 4541
• Hardness (Shore A) : 50-60
• Elongation : >500%
• Accelerated weathering, 500 hours : No chalking or cracking on the film

PACKAGING
20 kg plastic pails.

STORAGE &SHELFLIFE
The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.

TECHNICAL SERVICE
The ABADGARAN INTERNATIONAL GROUP Technical Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.

ELASTOPOOL is non-toxic but is alkaline in its nature. When applying gloves and goggles should be worn. Wash off splashes to skin with water. If in eyes wash out with plenty of clean water and seek medical attention. For further information refer to the material safety data sheet.

MSDS is available at ABADGARAN website.