ABABITUMER comprises a single component protective and waterproof coating with excellent adhesion and elasticity to substrates.
Dilute ABABITUMER with water to form a layer of primer on the substrate. After drying the first layer (primer), apply ABABITUMER on the prepared surface by brush, roller or spray.
High adhesion to substrates.
After drying, leave a flexible and elastic layer on substrate.
No droop and sag after a run.
Excellent resistance to chlorine and sulfate ions.
No solvents or fire hazard.
Tanking and waterproofing structures: to provide an impervious waterproof membrane on concrete and brick.
Floors: to provide a sandwich membrane in new construction or a surface treatment.
Walls: for interior and exterior walls.
Physical state: liquid
Specific gravity: 0.9± 0.05 g/cm3
pH: 9.0± 0.5
Solubility: Soluble in water before drying
Time of initial drying: 2-4 hours @ 25° C
Time of final drying: 7 days
Depending on the porosity of substrate, about 1 to 2 kg will be adequate to cover one square meter.
Shelf life: 1 year in the original package
Storage condition: should be protected from direct sunlight and frost. Keep pail in the temperature range between +10 and +30° C
Packing: 25 kg pail
The Abadgaran International Technical Service Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.
This product does not contain any substances hazardous to human health and the environment. However, it should not be swallowed and allowed to be contact with skin and eyes. In the case of contact with eyes rinse immediately with plenty of water. When applying gloves &goggles should be worn. For further information refer to the material safety data sheet.