POWER PLAST–RM

DOSAGE
The optimum dosage of POWER PLAST-RM can be determined by trials in the site.
Depending on concrete mix design (sizes and types of aggregates, cement content,
water/cement ratio, ambient temperature and concreting conditions), a dosage of between
0.3 and 0.9 percent by weight of cement or cementitious material is recommended.
For use with other range of dosage, contact ABADGARAN Technical Services Department.

DIRECTION OF USE
1-POWER PLAST-RM could be added to a part of concrete mixing water then added to the concrete mix.
2- POWER PLAST-RM could be added to the concrete mix during the mixing cycle at the
same time as the water or the aggregate or it could be added to ready-mix concrete before placing concrete.
3- Admixtures must be weighed carefully.

ADVANTAGES

• Provides excellent slump retention.
• Reduces cement content in concrete.
• Creating fluidity of concrete before setting (increased concrete workability).
• Design of concrete mixes with water-cement ratios in the range of 0.3 to 0.4
• Prevents bleeding and segregation of concrete.
• No needs for vibrators.
• Improves concrete consistency.
• Improves pumpability of concrete.
• It can be used with all types of Portland cement including Sulphate Resisting.
• Use simultaneously with silica fume, fly ash and other pozzolanic materials.
• Enables production and transportation of concrete over long distances.
• Prevents cold joint.
• Increases the compressive strength of concrete.
• Allows reduction of curing cycles - i.e. time or temperature.
   

APPLICATION

• Hot weather concreting
• Exposed concretes
• Mass concrete
• Concreting in thin and congested steel reinforcement sections
• Produces High Performance Concrete (HPC)
• Produces High Strength Concrete (HSC)
• Produces Self-Consolidating Concrete (SCC)
• Produces Water Resistant Concrete (WRC)
• Produces Preplaced Aggregate Concrete (PAC)
   

STORAGE
Shelf life: 1 year in the original package.
Storage condition: should be protected from direct sunlight and frost. Keep container in the temperature range between +10°C and +30°C.
Packing: 22 kg container or 1000 kg tank.

HEALTH AND SAFETY
This product does not contain any substances hazardous to human health and the environment. However,

it should not be swallowed or allowed to be in contact with skin and eyes.

In case of contact with eyes, rinse immediately with plenty of water. For further information refer to the material safety data sheet.
POWER PLAST–RM is not flammable. MSDS is available at ABADGARAN website.