Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.



POWER PLAST-R is a high range water reducing and super plasticizing admixture based on
modified polycarboxylic (PC) polymers. It provides excellent slump retention.
It meets the requirements of the following standards:
ASTM C1017/C1017 M, ASTM C494/C494 M TYPE F
EN 934
ISIRI 2930

The optimum dosage of POWER PLAST-R can be determined by trials in the site. Depending on concrete mix design (sizes and types of aggregates, cement content, water/cement ratio,
ambient temperature and concreting conditions), a dosage between 0.3 and 1.0 percent by weight of cement or cementitious material is recommended.
For use with other range of dosage, contact ABADGARAN Technical Services Department.

1- POWER PLAST-R could be added to a part of concrete mixing water then added to the concrete mix.
2- POWER PLAST-R could be added to the concrete mix during the mixing cycle at the same
time as the water or the aggregate or it could be added to ready-mix concrete before placing concrete.
3- Admixture must be weighed carefully.


  • Provides excellent slump retention.
  • Reduces cement content in concrete.
  • Less or no vibration needed.
  • Reduces rate and heat of hydration.
  • Improves concrete consistency.
  • Improves pumpability of concrete.
  • Compatible with all Portland cement types.
  • Can be used simultaneously with silica fume, fly ash and other pozzolanic materials.
  • Enables production and transportation of concrete over long distances.
  • Prevents cold joint and cracks.
  • Increases the compressive strength of concrete.
  • Removes air bubbles in fresh concrete resulting in less air voids in hardened concrete.



  • Hot weather concreting
  • Transportation of concrete over long distances
  • Mass concrete
  • Exposed concrete
  • Concreting in thin and congested steel reinforcement sections
  • Concrete pavements, bridges, sewage works, etc.

Chemical base

 modified polycarboxylic (PC) polymers

Specific gravity

 1.09 ± 0.05 g/cm3

Physical state


Chloride content

 Nil to EN 934


  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and frost. Keep container in the temperature range between +10°C and +30°C.
  • Packing: 22 kg container or 1000 kg tank

This product does not contain any substances hazardous to human health and the environment.
However, it should not be swallowed or allowed to be in contact with skin and eyes.
In case of contact with eyes, rinse immediately with plenty of water.

For further information refer to the material safety data sheet.
POWER PLAST-R is not flammable. MSDS is available at ABADGARAN website.