Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.



Standard tile mortar DESCRIPTION Thin bed mortar for placing and fixing ceramic tiles


ABATILESET adheres to all solid, load-bearing, clean, dry and moist surfaces free of substances which can cause separation. Remove any coatings with inadequate bonding strength. Depressions of up to 5mm depth can be repaired with ABATILESET the day before. Prime absorbent substrates such as calcium sulphate screeds, lightweight concrete, plasterboards and gypsum plasters, sandwich type and fibrous plasterboards with E.M.BOND. Allow the priming coat to dry for approx. 4 hours.

  • high bonding strength
  • easy to apply
  • available in white and grey
  • for layer thicknesses of up to 5 mm
  • suitable for wet areas


ABATILESET is suitable for placing and laying ceramic tile coverings (water absorption higher than 3 percent) indoors on absorbent substrates, even in wet areas.
Stir ABATILESET into clean, clear water until it is completely free of lumps. Approx. 5.5 l of water are needed to prepare 25 kg of ABATILESET. Leave to mature for approx. 5 minutes and stir again. Apply the mortar according to the recognized rules of the thin-bed method. The skin formation time has always to be tested before applying the tiles. Apply by a notched spreader with suitable toothing to insure a contact area between mortar and tile of at least 65%. Fresh excess mortar can be removed with water, once hardened material can only be removed mechanically. Ready for grouting after 24 hours.


Base :   Polymer-modified cement combination with mineral fillers.
(Thin-bed mortar according to DIN EN 12004 C1)

Bulk weight :  Approx. 1.4 g/cm3
Mixing ratio :   Approx. 5.5 l of water for 25 kg of powder.
Maturing time :    5 minutes.
Application temperature :   +5°C to +40°C.
Application time :   Approx. 1 hour.
Slip :    ≤ 0.10 mm.
Temperature resistance :    –30°C to +70°C.
Tensile adhesion strength :    ≥ 0.5 N/mm2.
Amount required (kg/m2) :   2.5-4.



25 kg plastic bag.
Approx. 12 months if stored in a tightly sealed container, in cool and dry conditions. Use product in opened containers as soon as possible.
The Abadgaran International Technical Service Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.



  • ABATILESET contains cement and reacts with water, producing an alkaline solution. Always protect skin and eyes. In case of contact, wash immediately with plenty of water. After eye contact seek medical advice. MSDS is available from Abadgaran.