Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info[At]

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.




The surface and thin-bed mortar, dispersion adhesive or thick-bed mortar (at least 7 days old) must have set sufficiently hard and dry. Scraped joints must first be wetted. In case of tile covering with a porous or non-scratchproof surface test suitable for ABA TILEGROUT for grouting.

  • brilliant colors
  • uniform joint appearance
  • high filling power
  • easy to apply
  • also for use with under-floor heating
  • Fine grouting mortar, particularly easy to apply, for filling joints in ceramic wall and floor coverings, glass and porcelain mosaics, both indoors and outdoors. The very high filling power and easy wash-ability of ABA TILEGROUT ensures rapid and efficient grouting work. For joints up to 6 mm width.
  • Stir ABA TILEGROUT into clean, clear
  • water until it is completely free of lumps. Make sure that the grouting mortar
  • has a uniform, homogeneous colour after mixing.
  • Apply the joint filler using the slurry
  • technique. Wipe over and clean freshly grouted tiles with a damp sponge. Remove
  • the dry film later with a soft cloth. Dampen the freshly grouted joints after
  • 24 hours to prevent surface moisture deficiency.
  • Floor tiles can be walked on after only
  • 12 hours.

Base: Cement with natural mineral fillers and high-quality synthetic resin powder
Bulk weight: Approx. 1.1 g/cm3
Mixing ratio: Approx. 1 .5 l of water for 5 kg of powder
Maturing time: 5 minutes
Application temperature: +5° C to +25° C
Application time: Approx. 2 hours
Washable: after only 15 minutes, depending on the tiling material
Ready for foot-traffic: after 12 hours
Full load-bearing strength: after 2 days
Temperature resistance: -20° C to +70° C
Amount required (kg/m2): 0.2-0.8 (depending on the tile size and joint width)

5 kg plastic bags
Approx. 12 months if stored in atightly sealed container, in cooland dry conditions. Use productin opened containers as soon aspossible.
The ABADGARAN INTERNATIONAL GROUP Technical Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.

ABA TILEGROUT contains cement and reacts with water, producing an alkaline solution. Always protect skin and eyes. In case of contact, wash immediately with plenty of water. After eye contact seek medical advice. For further information refer to the material safety data sheet.
MSDS is available at ABADGARAN website.

Expect Something Extra