Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info[At]abadgarangroup.com

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.

ABADUR-201

TWO COMPONENTS POLYAMIDE CURED EPOXY ZINC RICH PRIMER

DESCRIPTION

 A two component polyamide cured epoxy zinc rich primer with a superior resistance to water, weather and abrasion. It gives a cathodic protection film with the maximum performance on structural steel, machinery, pipes and tanks exterior in paper mills, oil refineries, power plants, chemical process and waste treatment plants as well as decks, hulls and superstructures of ships, barges and workboats, offshore platforms and related structures. With a proper topcoat, withstands splash or spillage of water, solvents, chemicals and petroleum products. Like all primers, ABADUR-201 alone is not suitable for immersion in acid or alkaline solutions.

APPLICATION

  • Material is supplied in two containers as a unit. Always mix a complete unit in the proportion supplied. Once the unit has been mixed it must be used within the working Pot life specified.
  • Agitate part A with a power agitator.
  • Combined entire contents of curing agent (part B) With Base (Part A) and mix thoroughly with power agitator. Stir during application to maintain uniformity of material.
  • To prevent moisture condensation during application, surface temperature must be at least 3 ºC above the dew point.
  • In hot climate, material temperature should be 20 to 25 ºC prior to mixing; otherwise pot life becomes very short.
  • For satisfactory cure, air and surface temperature must be above 10 ºC
  • Paint shall not be applied when wind speed is in excess of 7 m/s.

ADVANTAGES

  • High adhesion to surface
  • High mechanical strength
  • Abrasion resistant
  • Water and chemical resistance

FIELD OF APPLICATION

  • Refineries
  • Marine structures
  • Chemicals tanks
  • Wastewater treatment plants
Color  Grey
Mixing Ratio  (A:B) 100:8 (by weight)
Density  (A+B) 0.3 ± 0.1 g/cm3
Volume  solid 60 ± 3 %
Coverage  8 m²/lit (75 micron dry film thickness)
Typical dry film thickness  60-75 μm
Number of coat  One 
Amount of added thinner  5% - 10% 
Application method Conventional or airless spray, brush or roller
Substrate Blasted steel
Induction time  20-30 minutes
Flash point  28°C
Thinner/Cleaner  T-200

PACKAGING

27 kg set

Part A (Base): 25 kg

Part B (Hardener): 2 kg

 

STORAGE & SHELFLIFE

The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight. Keep in the temperature range between +10°C and +30°C.

HEALTH & SAFETY

This product is Flammable. Keep away from heat and open flame .Keep container closed .Use with adequate ventilation. Avoid prolonged and repeated contact with skin. If used in confined areas, observe the following precautions to prevent hazards of fire or explosion or damage to the health:

1-Circulate adequate fresh air continuously during application and drying.

2-Use fresh air masks and explosion proof equipment.

3- Prohibit all flames, sparks, welding and smoking.

MSDS is available at ABADGARAN website.

Expect Something Extra