QUICK SETTING MORTAR TO PLUG ACTIVE WATER LEAKS
DESCRIPTION
ABAPLUG, when mixed with clean water, provides a ready to use quick setting durable plugging
mortar for pressure water leaks in concrete and masonry.
SURFACE PREPARATION
Prepare concrete or rock in “V” shape around leak. Remove loose material, Clean cavity completely.
Lightly dampen the substrate just prior to application if necessary.
MIXING
Mixing should only be done by hand. Mix with clean water to obtain desired consistency. Do not over-mix.
Do not over-wet. Do not retemper. Mix ratio water:powder is 1:5.
APPLICATION
Force ABAPLUG into the crack or hole by hand or with a trowel. Rapidly fill to the full depth of the opening.
Start filling from outside work toward center of the leak. The material should beheld in place & leveled off.
For heavy water infiltration through crack, Insert a tube and seal in position with ABAPLUG firstly.
Then remove or cut the tube and seal with ABAPLUG.
ADVANTAGES
FIELD OF APPLICATION
Appearance |
Gray powder |
Bulk density |
1.5±0.1 g/cm3 |
Specific Gravity of Paste |
2.15±0.1 g/cm3 |
pH Value (10% Conc.) |
13.5±0.5 |
Setting time |
20-40 seconds |
PACKAGING
8kg plastic pails.
STORAGE & SHELFLIFE
The shelf life is 6 months if unopened, stored free from frost, moisture and direct sunlight.
HEALTH & SAFETY
ABAPLUG is alkaline, use protective gloves. If gets into eyes clean out with water immediately,and contact a physician. Mix in small quantities. MSDS is available at ABADGARAN website.