Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.



E.M.AIR is an air-entraining admixture for use in concrete and mortar. It is used to improve workability, cohesion, and durability of concrete and mortar by the ultra-stable air bubbles with appropriate size and spacing factor, uniformly distributed throughout the mixture.

E.M.AIR provides freeze thaw protection in cold climates.

E.M.AIR meets the requirements of the following standards: 

ASTM C260, ASTM C666, ASTM C233, ASTM C457


ISIRI 2930 


The rate of use of an air-entraining admixture depends on the air content (4–6 % typically) to be obtained along with many other factors.

The optimum dosage of E.M.AIR can be determined by trials in the site. Depending on concrete mix design (sizes and types of aggregates, cement content, water/cement ratio, ambient temperature and concreting conditions), a dosage of between 0.1 and 0.4 percent by weight of cement or cementitious material is recommended.

For use with other range of dosage, contact ABADGARAN GROUP Technical Services Department.

Please contact our engineering office in case of simultaneously use of more than one admixture.



1- E.M.AIR could be added to a part of concrete mixing water then added to the concrete mixture.

2- E.M.AIR could be added to ready-mixed concrete before placing concrete.

3- Admixtures must be weighed carefully.


  •  Increases freeze/thaw damage resistance.
  •  Improves permeability and durability.
  •  Improves harsh mixtures.
  •  Improves concrete consistency (plasticity and workability).
  •  Cohesion of mixtures is improved and bleeding reduced.
  •  Eliminates segregation.
  •  Ready to use - no dilution is required.



  • Workable and durable concrete for dams and reservoirs, tunnels, mass concrete structures, roads, runways, taxiways and etc.
  •  Air-entrained concrete in cold weather condition.
  • Pre-cast concrete sections.

Physical state



 Transparent Yellow

Specific gravity

 1.01±0.05 g/cm3


 Soluble in water

Chloride content

 Nil to EN 934


  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and frost. Keep container in the temperature range between +10 and +30°C.
  • Packing: 20 kg container.


This product does not contain any substances hazardous to human health and the environment. However, it should not be swallowed and allowed to be contact with skin and eyes. In case of contact with eyes rinse immediately with plenty of water. When applying gloves & goggles should be worn. E.M.AIR is not flammable.

For further information refer to the material safety data sheet. MSDS is available at ABADGARAN website.