Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.




A.C.P is an advanced concrete admixture used for designing high performance concrete and multipurpose concrete mixtures. A.C.P is based on a highly pozzolanic mineral material which significantly reduces absorption and permeability of concrete, besides increasing workability.High range water reduction and workability retention are special properties of A.C.P. 

A.C.P comprises the following chemicals:

  1. Silica fumes
  2. New generation super plasticizers
  3. Waterproofing agents
  4. Catalysts and fillers

This advanced-technology product meets the requirements of the following standards:

ASTM C1202

BS EN 12390-8, BS 1881-122


The optimum dosage of A.C.P can be determined by trials in the site. Depending on concrete mix design (concrete type, workability, compressive strength, sizes and types of aggregates, cement content, water/cement ratio, ambient temperature and concreting conditions), a dosage between 5.0 and 9.0 percent by cement weight is recommended.

Note: when using A.C.P, water-cement ratio must be considered around 0.40.

For using other ranges of dosage, contact ABADGARAN INTERNATIONAL GROUP Technical Services Department.

Please contact our engineering office in case of simultaneous use of more than one admixture.



A.C.P can be added to concrete in two ways:

1-A.C.P could be added to ready-mix concrete before placing concrete.

2-A.C.P could be added to a part or whole of concrete mixing water then added to the concrete mix.



  • Reduces water-cement ratio.
  • Reduces cement content in concrete between 15 to 20 percent.
  • Increases workability and workability retention of concrete.
  • Improves pumpability of concrete and reduces depreciation of concreting equipment.
  • It can be used with all types of Portland cement.
  • Possibility of replacement of cement type 2 by cement type 5 when applied.
  • Increases the compressive strength of concrete about 30%-70%.
  • Considerably reduces permeability.
  • Increases the abrasion resistance of concrete.
  • Reduces the potential for AAR (Alkali-Aggregate Reaction).
  • Inhibits chloride ion penetration and any other destructive chemicals influence.


  • Enables production and transportation of concrete in long distances and hot weather concreting.
  • Produces High Strength Concrete (HSC) and Water Resistant Concrete (WRC).
  • Suitable for marine environments or the regions exposed to chemicals attack, e.g. southern and northern parts of Iran and saline regions.
  • Docks, deck bridges, tanks, etc.
  • Designs of concrete mixes for Water and Wastewater Treatment.

Physical state


Specific gravity

 1.43+ 0.05 g/cm3


 Dark grey


  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and frost. Keep pail in the temperature range between +10°C and +30°C.
  • Packing: 25 kg pail.


This product does not contain any hazardous substance to human health and the environment.

However, it should not be swallowed and contacted with skin and eyes.In case of contact with eyes, rinse with plenty of water immediately.

A.C.P is not flammable.

For further information refer to the material safety data sheet.

MSDS is available at ABADGARAN website.