Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.



POWER GEL improves the rheological properties of concrete. It is based on a highly pozzolanic mineral material which significantly reduces water absorption and increases the compressive strength and makes concrete impermeable. High range water reduction and workability retention are special properties of POWER GEL.

POWER GEL comprises the following chemicals:

  1. Silica fume.
  2. New generation super plasticizer based on modified polycarboxylic (PC) polymers.

This advanced-technology product meets the requirements of the following standards:

ASTM C1202

BS EN 12390-8, BS 1881-122


The optimum dosage of POWER GEL can be determined by trials in the site. Depending on concrete mix design (concrete type, workability, compressive strength, sizes and types of aggregates, cement content, water/cement ratio, ambient temperature and concreting conditions), a dosage of between 1.0 and 3.0 percent by weight of cement is recommended.

For use with other range of dosage, contact ABADGARAN Technical Services Department.

Note: please contact our engineering office in case of simultaneously use of more than one admixture.



POWER GEL can be added to concrete in two ways:

1-POWER GEL could be added to ready-mix concrete before placing concrete.

2-POWER GEL could be added to a part or whole of concrete mixing water then added to the concrete mix.


  • Reduces water-cement ratio.
  • Reduces cement content in concrete, at least 20 percent.
  • Increases workability and workability retention of concrete.
  • Increases flexural, tensile and compressive strength of concrete.
  • Achievement of early compressive strength of concrete.
  • Improves pumpability of concrete and reducing depreciation of concreting Equipments.
  • Improves concrete consistency.
  • Enables economies in mix designs to be achieved when special conditions such as chemicals attack, dynamic load, etc.
  • Considerably reduces permeability.
  • Increases durability of concrete.
  • Reduce damages caused by lack of correct curing method.
  • Increases the abrasion resistance of concrete.
  • Reduce the risk of cracks in concrete.


  • Produces High Strength Concrete (HSC) in special conditions (high dynamic loads).
  • Produces non-osmosis concrete for the regions exposed to chemicals attack.
  • Reinforced  and non-reinforced concrete.
  • Dams, water and wastewater treatment, bridges, channels, etc.
  • Hot weather concreting.
  • Produces resistant concrete against explosion and fire.


Physical state


Specific gravity

 1.23+ 0.05 g/cm3


 Dark gray 


  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and frost. Keep pail in the temperature range between +10°C and +30°C.
  • Packing: 24 kg container.


This product does not contain any substances hazardous to human health and the environment. However, it should not be swallowed and contact with skin and eyes. In case of contact with eyes, rinse immediately with plenty of water. POWER GEL is not flammable.

For further information refer to the material safety data sheet. MSDS is available at ABADGARAN website.