Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.


ABAINJECT EP-110 is a two components, solvent-free, low viscosity Injection-Adhesive, based
on high strength epoxy resins and special Hardener to form a permanent bond or seal. It conforms
to ASTM C881 and EN 1504-5.


ABAINJECT EP-110 is supplied in two containers as a unit. Always mix a complete unit in the proportion supplied.
 Once the unit has been mixed it must be used within the working Pot life specified.

1-Agitate Part A and B separately with a power agitator.
2-Combine entire contents of curing agent (part B) with base (part A) and mix thoroughly with power agitator
3-Mix thoroughly for at least three minutes, scraping the container bottom and side to assure complete mixing. 

There is no induction or waiting time required after mixing before injection.
Mixed ABAINJECT EP-110 can be injected under pressure into the cracks using a single component injection pump,
or a high pressure Hand Pump. Injection ports (packers) are set at approx. 25 cm intervals beside the crack and the crack between
the injection ports (packers) sealed with ABADUR-P to prevent injection resin to escape during the injection process.
Vertical cracks should always be injected from the bottom upwards. 
As soon as injection resin oozes out of the next packer / injection port, the first one is sealed and the injection process continued from
the next one. After completion of the injection process, the injection ports (packers) as well as the sealing material between the ports are removed.


  • Excellent bond to concrete, brick and masonry.
  • Low viscosity for excellent penetration into existing cracks.
  • Injectable by a single component either manual or automated pumps.
  • Solvent free.
  • Resistant to wide range of chemicals.


  • Pressure injection of cracks in structural concrete, masonry, wood, etc.
  • Structural repairs.
  • Grouting bolts, dowels, pins into horizontal concrete surfaces.
  • Seals concrete from water absorption, chloride-ion intrusion and chemical attack.
  • Prolongs life of cracked concrete.

Appearance : Part A: white viscose liquid
Part B: black viscose liquid
Color : Light grey
Mixing Ratio (A:B) : 2:1(by weight)
Density (A+B) : Approx. 1.3 g/cm3
Volume solid : 100%
Flash point : 80°C
Cleaner : T-200
Application Temperature : +20°C ± 30°C


  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and moisture. Keep Gallons in the temperature range between +10°C and +30°C.
  • Packing: Pre-batched Part A+B: 1.6 x 0.8 kg units. 2.4 kg at Total.

For information and advice on the safe handling, storage and disposal of chemical products, users
shall refer to the most recent Material Safety Data Sheet (available on request) containing physical, ecological, toxicological and other safety-related data.