Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.


An environmentally friendly version of the company’s heritage release agent, AQUAFORM-230 is comprised of neutralized vegetable oils in mineral oil
that contains no waxes, silicones, or carcinogens; it’s also solventless and non-toxic.
Concepts of its art are established on last novel principles in production and developments of contemporary form Release Agents e.g. 
Green and most environment friendly composition to be made, provide long life and extensive reuse of
frameworks, to remain hard, non-powdery, stain-free concrete surface with a minimum number
of defects, permit clean release of formwork from the hardened concrete during stripping and Cost cuts in purchase and usage of them.

Surface Preparation: Forms must be clean and free of any dust, dirt, laitance, hardened
concrete or residue that might discolor new concrete.
Application: Apply AQUAFORM-230 with a brush, roller, or pressurized sprayer. Wipe off excess and drips with a clean, soft rag. 
Wait a minimum of 60 minutes before pouring Concrete.
New Wood Forms: Apply initial coat of AQUAFORM-230 at a rate of above recommended anddo not wipe. 
Allow release agent to absorb into wood surface. For extremely porous forms a second saturation coat may be necessary prior to first use. 
Allow forms to dry, then recoat and wipe excess as stated above.

Clean tools and equipment used to apply AQUAFORM-230 with detergent and warm water.



  • Low Volatile Organic Compound (V.O.C.) content.
  • Equally effective on all types of forming materials and form liners including elastomeric,PVC, and EPS.
  • Allows for fast and easy stripping of formwork.
  • Highly stable during placement and vibration of concrete.
  • Does not stain or contaminate the finished concrete surface.
  • Suitable for high detail forms and architectural concrete finishes.
  • Increased corrosion resistance to steel surfaces.
  • Extends the life of forms and inhibits oxidation of metal forms.
  • Reduces labor cost of stripping and cleaning forms and equipment.
  • Compatible with both type of static and slip-forming.

AQUAFORM-230 in general is formulated to be used for all case of wooden, plastic and metallic forms, etc.


Physical state




Solubility in Water

 totally miscible

Specific gravity of fresh mortar

 0.98±0.02 g/cm3


 No Case of differentiation in phases


  • Shelf life: 1 year in the original package
  • Storage condition: should be protected from direct sunlight and moisture. Keep Gallons in the
  • temperature range between +10°C and +30°C.
  • Higher temperatures could disrupt the stability of primary emulsion and would be needed to be premixed when using.
  • Packing: 20 lit Gallons

For information and advice on the safe handling, storage and disposal of chemical products,
users shall refer to the most recent Material Safety Data Sheet (available on request) containing
physical, ecological, toxicological and other safety-related data.