Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info@abadgarangroup.com

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.

ABADUR-280

SOLVET FREE HIGH BUILD, PROTECTIVE EPOXY RESIN COATING

DESCRIPTION

ABADUR-280 is a protective epoxy resin coating specifically designed to protect concrete and metal. Supplied as a two-component system, it requires only on site mixing to produce an easily applied decorative and chemically resistant finish. Due to epoxy modification, it is suitable to use in exterior area and provides high gloss, heavy bodied, ultra dense surface. This coatings will not support the growth of bacteria. The standard color is light grey.

APPLICATION

Material is supplied in two containers as a unit. Always mix a complete unit in the proportion supplied. Once the unit has been mixed it must be used within the working Pot life specified. 

1-Agitate Part A and B separately with a power agitator.                                                             

2-Combine entire contents of curing agent (part B) with base (part A) and mix thoroughly with power agitator

3-Mix thoroughly for at least three minutes, scraping the container bottom and side to assure complete mixing. There is no induction or waiting time required after mixing before application.

ABADUR-280 coating can be applied using good quality rollers or short haired brushes or by airless spray. For application by airless spray, use a 45:1 or higher ratio pump, minimum 9mm dia hoses and HD tip 19-23 thou. ABADUR-280 can be applied using good quality rollers or short haired brushes.

It is recommended that ABADUR-280 coating be applied in two coats to ensure complete coverage. Prior to the application of each coat the surface should be examined for signs of pin-holing, etc. Where pin-holing is evident these should be filled using ABADUR repair system.

If the over-coating is delayed more than the drying time table, the previous coat must be thoroughly abraded to give an adequate mechanical key and solvent wiped.

ADVANTAGES

  • Excellent chemical resistance
  • Resists chemical attack by chloride and salts of sea water
  • Non-toxic and applicable in hygienic environments
  • High durability

FIELD OF APPLICTION

  • Concrete and metal storage tanks
  • Chemicals, oil and fuel reservoirs
  • Pipeline coatings
Color Grey
Mixing Ratio (by weight) 1:1
Density (A+B) 1.75±0.10 g/cm3
Volume solid 100%
Coverage 0.35-1.75 kg/m²
Typical dry film thickness 200-1000 microns
Number of coats Two  
Application method Roller, brush or airless spray
Substrate Concrete, metal
Chemical resistance against sulfuric acid (50%) Excellent

PACKAGING

15kgs set

 

STORAGE & SHELFLIFE

The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.

HEALTH & SAFETY

This product is Flammable. Keep away from heat and open flame .Keep container closed .Use with adequate ventilation. Avoid prolonged and repeated contact with skin. If used in confined areas, observe the following precautions to prevent hazards of fire or explosion or damage to the health:

1-Circulate adequate fresh air continuously during application and drying.

2-Use fresh air masks and explosion proof equipment.

3- Prohibit all flames, sparks, welding and smoking.

MSDS is available at ABADGARAN website.

Expect Something Extra