Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info@abadgarangroup.com

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.

E.M.REPAIR

POLYMER MODIFIED CONCRETE REPAIR MORTAR
DESCRIPTION

E. M. REPAIR is a ready-mix and non-shrink cement base dry powder, provides smooth level
surfaces with highly consistent repair mortar for special purpose concrete and masonry repairs.
And due to polymer modified materials in it, it makes an excellent adhesion to most common substrate.
 
It meets the requirements of the following standards:
EN 1504-3

DOSAGE
The optimum dosage of E.M.REPAIR to meet specific requirement depending on porosity and
rough substrate, the normal dosage range is from 1.5 to 2.5 kg/m2/mm thickness of layer.


SURFACE PREPARATION
Surfaces should be clean sound and free from oil, grease, laitance and loose particles.
Metal surfaces should also be clean and free of rust, oil, grease and contaminants.
The concrete should be pre-saturated for preferably 6 hours with water before application.


MIXING
E.M.REPAIR is simply mixed with water to yield a stiff easily workable compound with shrinkage compensating properties.
The quantity of water depends on the desired consistency but as a guide, we recommended,
the entire contents of the bag should be added to the pre-measured (5-5.5 liters approximately) water while mixing.
Mix with a paddle mixer or trowel to ensure a homogenous lump free material is achieved.
Do not try to remix the product after losing workability by the addition of more water.

APPLICATION
1. Remove damaged concrete and prepare exposed steel reinforcement.
2. Thoroughly clean repair area using high pressure water jet to remove all loose debris and contamination.
3. Replace damaged concrete using E.M.REPAIR, build up in layers if necessary. Apply E.M.REPAIR with a trowel or spatula.
 Press hard by hand. Thicker repairs may be achieved by working in layers.


CURING
Keep repaired areas damp, with spraying water at least 24 hours.

 

ADVANTAGES

  • Excellent adhesion to most common substrates.
  • Non shrinkage.
  • Provides maximum protection against freeze and thaw cycles.
  • Same color with concrete.
  • Easy apply.
  • Ready mix.
     

FIELD OF APPLICATION

  • Repairing of cracks and porous surfaces.
  • Provides smooth level surfaces.
  • Filling pores and holes.
  • Underlayment for floors and walls before placement of new covering materials.
     

Physical state

 Powder

Color

 Gray

Specific gravity of fresh mortar

 ~1.90 g/cm³

Chloride ion

 Nil

Pot life

 20 minutes @ +25°C

STORAGE

  • Shelf life: 1 year in the original package.
  • Storage condition: should be protected from direct sunlight and moisture. Keep bag in the temperature range between +10°C and +30°C.
  • Packing: 25 kg bag.

HEALTH AND SAFETY
This product does not contain any substances hazardous to human health and the environment.
However, it should not be swallowed and contact with skin and eyes. 
In case of contact witheyes, rinse immediately with plenty of water. When applying gloves & goggles should be worn.
For further information refer to the material safety data sheet.
E.M.REPAIR is not flammable. MSDS is available at ABADGARAN website.

Expect Something Extra