Address No. 65, Shahid Ghandi St., North Sohrevardi Ave., Tehran, Iran

Phone +98 21 87754

E-Mail Address info[At]abadgarangroup.com

Abadgaran Group Office
Address End of West 6th St., Safadasht Industrial Zone, Safadasht, Malard Road, Karaj, Iran

Phone +98 21 65741911-5

Abadgaran Group Factory
Thank you for giving us the opportunity to serve you better. Please help us by taking a few minutes to tell us about the service that you have received so far.

E.M. SEAL

DESCRIPTION

E.M. SEAL is a clear silane based water repellent sealer which upon application will penetrate into the substrate for long-term protection and provide water repellency by chemically reacting with the substrate. It has a micro particle size to achieve deep penetration inhibiting water absorption into the substrate. When cured it does not alter the appearance of surfaces and being non-film forming will allow the substrate to breathe. It may be used on old or new structures.

Before using E.M. SEAL, it is important to ensure that the substrate to be treated must be clean surface-dry and free from dust and loose material. All contaminants such as oil, grease or any surface contamination must be removed to ensure adequate penetration when the product is applied. Previously painted surfaces must have all of the existing coating removed to allow penetration into the surface. Where surfaces have been water blasted or washed down to remove contamination they must be allowed to dry out completely before application is commenced otherwise impregnation will not occur. Cracked or damaged areas must be repaired and sealed prior to application of materials

  • Non film forming
  • Reduces water and chloride intrusion
  • Non staining
  • Ready to use &easy to apply
  • Chemically resistant to fuels, atmospheric contaminants &oils
  • Suitable for many substrates
  • Allows water vapour to escape from structure
  • Significantly reduces absorption of water whilst allowing the substrate to breathe
  • Helps to prevent efflorescence
  • Seals hairline crack up to 0.3 mm
  • UV stable to increase treatment life
  • Very good penetration
FIELD OF APPLICATION
Application includes preventing water damage in buildings, parking decks, garages, bridge and coastal structures, including exposed reinforced concrete to attack by chloride ions and water intrusion.
 
APPLICATION
E.M. SEAL should be applied in 2 flood coats (wet on wet) at an application rate of 0.2 liters/m2 per coat. It may be applied by roller, brush or portable knapsack spray. Do not contaminate with water. Before application, the substrate should be dry in order to achieve maximum penetration.
All equipment and containers must be clean and dry. After use they can be cleaned with any organic solvent alcohol or thinners.
  • Appearance Clear liquid
  • Specific gravity :  (ready mixed) Approx. 0.8 g /cm³
  • Average Depth of Penetration:  2-5 mm depending on the porosity
  • Consumption : Approx. 2 kg/m²per mm layer thickness

PACKAGING
4 &20 liter containers.


STORAGE &SHELFLIFE
The shelf life is 12 months if unopened, stored free from frost, moisture and direct sunlight.


TECHNICAL SERVICE
The Abadgaran International Technical Service Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.

HEALTH AND SAFETY
This product does not contain any substances hazardous to human health and the environment. However, it should not be swallowed or allowed to contact with skin and eyes. In case of contact with eyes rinse immediately with plenty of water. For further information refer to the material safety data sheet.
E.M.GROUT-500 is not flammable. MSDS is available at ABADGARAN website.


TECHNICAL SERVICE
The ABADGARAN INTERNATIONAL GROUP Technical Department is available to assist you in the correct use of our products and its resources are at your disposal entirely without obligation.

Expect Something Extra